八戒网站免费观看视频

Wuxi Dingfeng pressure vessel Co., Ltd. specializes in manufacturing electric heating reactor and stainless steel reactor
China chemical equipment manufacturer
With the third class pressure vessel manufacturing license
Special equipment manufacturing license No.: ts2210836-2020
  • Sales Hotline
  • seventeen billion three hundred and fifty-one million six hundred and eighty-eight thousand eight hundred and fifty-eight
stainless steel reactor

Current location: homepage > Product Center >

stainless steel reactor

What problems should be paid attention to in stainless steel reactor operation
I. the controller should connect the front line and the zero line correctly, the grounding wire is necessary to be grounded, and the wiring operation should be carried out without power transmission. Prevent operating the controller in oil, gas and other flammable and explosive environment. After the controller is powered on, do not pull or touch any plug during operation. When the stainless steel reactor equipment is used, the explosion relief port is connected to the outdoor through the pipeline.
2. When starting the machine, any button should be in the initial condition, and the button should be restored to its original condition after use.
3. Do not change the temperature setting value during heating after the temperature is determined.
4. Know about the introduction to prevent the medium from corroding the main data. If the medium reaction is too violent or there is a chemical reaction which corrodes the stainless steel severely, the corresponding special reactor should be selected.
5. When cleaning the autoclave, do not let water or other liquids flow into the heating furnace. When the reactor is not used for a long time, it should be cleaned and stored in a clean and dry place without corrosion.
Vi. regularly inspect the oil level of reaction kettle, various surfaces, explosion relief equipment and hot oil to ensure normal operation of the equipment.
7. When there is abnormal movement and static in the isolation sleeve, it is necessary to stop the machine to release pressure and check the mixing system. If the swing of mixing shaft is too large, the bearing or sliding sleeve should be replaced in time.
8. The reaction medium should not exceed 2 / 3 liquid level of the reactor. The reactor should not operate under overpressure and overtemperature. After completion, the reactor should not be disassembled under pressure.
9. The correct detection direction of the rotating speed display should not be adjusted at will. The orientation has been adjusted before delivery.

八戒网站免费观看视频_打飞专用高潮熟妇图片大全_粗大撑开紧窄的嫩缝

http://95.yqgww.cn http://05.yqgww.cn http://65.yqgww.cn http://74.yqgww.cn http://85.yqgww.cn http://78.yqgww.cn http://85.yqgww.cn http://88.yqgww.cn http://57.yqgww.cn http://83.yqgww.cn http://58.yqgww.cn