八戒网站免费观看视频

Wuxi Dingfeng pressure vessel Co., Ltd. specializes in manufacturing electric heating reactor and stainless steel reactor
China chemical equipment manufacturer
With the third class pressure vessel manufacturing license
Special equipment manufacturing license No.: ts2210836-2020
  • Sales Hotline
  • seventeen billion three hundred and fifty-one million six hundred and eighty-eight thousand eight hundred and fifty-eight
News and information

Current location: homepage > News and information >

Precautions for using stainless steel reactor

Precautions for using stainless steel reactor
1. The controller should connect the front line and the zero line correctly, the ground wire should be grounded, and the wiring operation should be carried out without power transmission. Do not operate the controller in flammable and explosive environment such as oil and gas. After the controller is powered on, do not pull the contact plug during operation. When the reactor equipment is used, the discharge port is connected to the outdoor through the pipeline.
2. When starting the machine, the buttons should be in the initial condition, and the buttons should be restored to their original conditions after using.
3. Do not change the temperature setting value during the heating process.
4. Know about the introduction. Do not let the medium corrode the main data. If the medium reaction is too violent or there is chemical reaction which corrodes stainless steel severely, the corresponding special reactor should be selected.
5. When cleaning the autoclave, do not let water or other liquids flow into the heating furnace. When the reactor is not used for a long time, it should be cleaned and stored in a clean and dry place without corrosion.
6. Regularly check the oil level of reaction kettle, surface, discharge equipment and hot oil, so that the equipment can operate normally.
7. When there is abnormal movement and static in the sleeve, it is necessary to stop the machine to release pressure and check the mixing system. If the swing of mixing shaft is too large, the bearing or sliding sleeve should be replaced in time.
8. The reaction medium should not exceed 2 / 3 liquid level of the reactor, the reactor should not operate under overpressure and overtemperature, and the reactor should not be disassembled under pressure after completion.
9. The correct detection direction of rotating speed display should not be adjusted at will, but it has been adjusted before delivery.

八戒网站免费观看视频_打飞专用高潮熟妇图片大全_粗大撑开紧窄的嫩缝

http://58.yqgww.cn http://18.yqgww.cn http://24.yqgww.cn http://66.yqgww.cn http://28.yqgww.cn http://74.yqgww.cn http://13.yqgww.cn http://10.yqgww.cn http://40.yqgww.cn http://62.yqgww.cn http://86.yqgww.cn